SIM5300E AT Command Manual V1.02
<PDP_type> (Packet Data Protocol type)
IP Internet Protocol (IETF STD 5)
IPv4 Internet Protocol, version 6 (IETF RFC 2460)
IPv4v6
V
irtual <PDP_type>int
roduced t
o handle dual IP s
t
ack UE
capability (see 3GPPTS 24.301[83])
<APN> (Access Point Name) A string parameter (string should be included in
quotation marks) which is a logical name that is used to select the GGSN or
the external packet data network. If the value is null or omitted, then the
subscription value will be requested.The default value is NULL.
<PDP_addr> A string parameter (IP address).
Format:"<n>.<n>.<n>.<n>" where <n>=0..255
If the value is null or equals 0.0.0.0 a dynamic address will be requested. The
allocated address may be read using the +CGPADDR command
<d_comp> A numeric parameter that controls PDP data compression
0 –PDP data compression off (default if value is omitted)
<h_comp> A numeric parameter that controls PDP data compression
0 –PDP header compression off (default if value is omitted)
Reference
6.2.3 AT+CGQMIN Quality of Service Profile (Minimum Acceptable)
AT+CGQMIN Quality of Service Profile (Minimum Acceptable)
Test Command
AT+CGQMIN=?
Response
+CGQMIN: <PDP_type>,(lis
t of supporte
d <pre
cedence>s),(lis
t of supporte
d
<dela
y>
s),(
lis
t o
f supp
or
te
d <r
elia
bility
>s),(
lis
t of s
upp
ort
ed
<pe
ak>s)
,(lis
t of
supported <mean>s)
[<CR><LF
>+CGQ
MIN:
<PDP_
type>,
(list of supported <precedence> s),(list of supported <delay>s),(list of supported <reliability>s),(list of supported
<peak>s),(list of supported <mean>s)
[…]]
OK
To Next Page
Loading...
Need help?
General
