SIM5300E AT Command Manual V1.02
0 CLIP not provisioned
1 CLIP provisioned
2 unknown (e.g. no network, etc.)
Reference
3.2.19 AT+CLIR Calling Line Identification Restriction
AT+CLIR Calling Line Identification Restriction
Test Command
AT+CLIR=?
Response
+CLIR: (list of supported <n>s)
OK
Read Command
AT+CLIR?
Response
+CLIR: <n>, <m>
OK
If error is related to ME functionality:
+CME ERROR: <err>
Write Command
AT+CLIR=<n>
Response
TA restricts or enables the presentation of the CLI to the called party when
originating a call.
The Command overrides the CLIR subscription (default is restricted or
allowed) when temporary mode is provisioned as a default adjustment for all
foll
owing outgoing calls. This adjustment can be revoked by using the
opposite Command.
OK
If error is related to ME functionality:
+CME ERROR: <err>
Parameters <n> (parameter sets the "Call line identification" adjustment for outgoing
calls:):
0 presentation indicator is used according to the subscription of
the CLIR service
1 CLIR invocation
2 CLIR suppression(default)
<m> (parameter shows the subscriber CLIR service status in network):
0 CLIR not provisioned
1 CLIR provisioned in permanent mode
To Next Page
Loading...
