SIM5300E AT Command Manual V1.02
2.2 Detailed Description of ATC According to
V.25TER
2.2.1 A/ Re-issues the Last Command Given
A/ Re-issues the Last Command Given
Execution Command
A/
Response
Re-issues the previous Command
Reference V.25 te r
2.2.2 ATA Answer an Incoming Call
ATA Answer an Incoming Call
Execution Command
ATA
Response
TA sends off-hook to the remote station.
Response in case of data call, if successfully connected
CONNECT<text> TA switches to data mode.
Note: <text> output only if ATX<value> parameter setting with the <value>>0
When TA returns to Command mode after call release
OK
Response in case of voice call, if successfully connected
OK
Response if no connection
NO CARRIER
Reference
V.2 5ter
Note:
Any additional commands on the same Command line are ignored.
This Command may be aborted generally by receiving a character
during execution. The aborting is not possible during some states of
connection establishment such as handshaking.
2.2.3 ATD Mobile Originated Call to Dial A Number
ATD Mobile Originated Call to Dial A Number
Execution Command
ATD<n>[<mgsm][;]
Response
This Command can be used to set up outgoing voice, data or fax calls. It also
serves to control supplementary services.
Note: T
his Command may be aborted generally by receiving an ATH
To Next Page
Loading...
