SIM5300E AT Command Manual V1.02
<toda> GSM 04.11 TP-Destination-Address Type-of-Address octetin integer
format (when first character of <da> is + (IRA 43) default is 145, otherwise
default is 129)
<mr> GSM 03.40 TP-Message-Reference in integer format
Reference
3GPP TS 27.005
4.2.8 AT+CNMI New SMS Message Indications
AT+CNMI New SMS Message Indications
Test Command
AT+CNMI=?
Response
+CNMI: (list of supported <mode>s),(list of supported <mt>s),(list of
supported <bm>s),(list of supported <ds>s),(list of supported <bfr>s)
OK
Read Command
AT+CNMI?
Response
+CNMI: <mode>,<mt>,<bm>,<ds>,<bfr>
OK
Write Command
AT+CNMI=<mode>[,<mt>[,<bm
>[,<ds>[,<bfr>]]]]
Response
TA selects the procedure for how the receiving of new messages from the
network is indicated to the TE when TE is active, e.g. DTR signal is ON. If TE
is inactive (e.g. DTR signal is OFF), message receiving should be done as
specified in GSM 03.38.
OK
ERROR
Unsolicited result code
1. Indicates that new message has been received
If <mt>=1:
+CMTI: <mem3>, <index>
If <mt>=2 (PDU mode enabled):
+CMT
: [<alpha>
],<length><CR><LF><pdu>
If <mt>=2 (text mode enabled):
+CM
T
: <oa>,
<scts>[
, <to
oa>, <fo
>, <pi
d>, <
dcs>,
<sca
>, <tos
ca>,
<length>]<CR><LF><data>
2. Indicates that new cell broadcast message has been received
If <bm>=2 (PDU mode enabled):
To Next Page
Loading...
Need help?
General
