SimCom SIM5300E

SIM5300E AT Command Manual V1.02
105
Test Command
AT+CSGS=?
Response
+CSGS: (list of supported <mode>s)
OK
Read Command
AT+CSGS?
Response
+CSGS: <mode>
OK
Write Command
AT+CSGS=<mode>
Response
OK
If error is related to ME functionality:
+CME ERROR: <err>
Parameters <mode>
0 Disable
1
Enable, the netlight will be forced to enter into 64ms
on/300ms off blinking state in GPRS data transmission
service. Otherwise, the netlight state is not restricted.
Reference
5.2.23 AT+SJDR Jamming detection
AT+SJDR Jamming detection
Read Command
AT+SJDR?
Response
+SJDR: <status>
or
+SJDR: <status>,<mode>,<var>,<display>,<result>
OK
Write Command
Enable jamming detection
AT+SJDR=<status>,<mode>[,<var
>[,<display>]]
Close jamming detection
AT+SJDR=0
Response
OK
Unsolicited result codes supported:
+SJDR: NO JAMMING
or
+SJDR: JAMMING DETECTED
or
+SJDR: INTERFERENCE DETECTED
Parameters <status>
0 disable jamming detection
1 enable jamming detection
SIMCOM CONFIDENTIAL FILE