SimCom SIM5300E User Manual

SIM5300E AT Command Manual V1.02
84
Parameters <mode>
0 Message types specified in <mids> and <dcss> are accepted
1 M
essage types specified in <mids> and <dcss> are not
accepted.
<mids> String type
(string should be included in quotation marks); all
different possible combinations of CBM message identifiers (refer <mid>)
(default is empty string); e.g. "0,1,5,320,922". Total 15 different <mids>
values can be supported. <mids>
values cannot be written consecutively,
such as "100-200"
<dcss> String type(string should be included in quotation marks); all
different possible combinations of CBM data coding schemes (refer <dcs>)
(default is empty string); e.g. "0,5". Total 5 different <dcss> values can be
supported. <dcss> values cannot be written consecutively, such as "0-5".
Reference
3GPP TS 27.005
Note
 AT+CSCB=0 will reset <mids> and <dcss> and select no <mids> and
no <dcss>.
 AT+CSCB=1 means all <dcss> are accepted but this command has no
effect on the list of the <mids> accepted. "0-255" means all <dcss>
are accepted.
 AT+CSCB=0, <mids> will add the <m
ids> values in the <mids>
current list handled by module.
 AT+CSCB=0, ,<dcss> will add the <dcss> values in the <dcss> current
list handled by module.

If AT+CSCB=0, <mids> is received while the list of <mids> is full, OK
is returned and new value is not added.
4.2.12 AT+CSDH Show SMS Text Mode Parameters
AT+CSDH Show SMS Text Mode Parameters
Test Command
AT+CSDH=?
Response
+CSDH: (list of supported <show>s)
OK
Read Command
AT+CSDH?
Response
+CSDH: <show>
OK
Write Command
AT+CSDH=[<show>]
Response
TA deter
mines whether detailed header information is shown in text mode
result codes.
OK
SIMCOM CONFIDENTIAL FILE

SimCom SIM5300E Specifications

General

Brand	SimCom
Model	SIM5300E
Category	Control Unit
Language	English