SimCom SIM5300E

SIM5300E AT Command Manual V1.02
165
Test Command
AT+CIPSRIP=?
Response
+CIPSRIP: (list of supported <mode>s)
OK
Read Command
AT+CIPSRIP?
Response
+CIPSRIP: <mode>
OK
Write Command
AT+CIPSRIP=<mode>
Response
OK
If error is related to ME functionality:
+CME ERROR: <err>
Parameters <mode> A numeric parameter which shows remote IP address and port.
0 Do not show the prompt
1 Show the prompt, the format is as follows:
1) For single IP connection (+CIPMUX=0)
+RECV FROM:<IP ADDRESS>:<PORT>
1) For multi IP connection (+CIPMUX=1)
+RECEIVE,<n>,<data length>,<IP ADDRESS>:<PORT>
Reference
7.2.22 AT+CIPDPDP Set Whether to Check State of GPRS Network
Timing
AT+CIPDPDP Set Whether to Check State of GPRS Network Timing
Test Command
AT+CIPDPDP=?
Response
+CIPDPDP: (list of supported<mode>s, l
ist of supported <interval>, list of
supported <timer>)
OK
Read Command
AT+CIPDPDP?
Response
+CIPDPDP: <mode>, <interval>, <timer>
OK
Write Command
AT+CIPDPDP=<mode>[,<interv
al>,<timer>]
Response
OK
If error is related to ME functionality:
SIMCOM CONFIDENTIAL FILE