SIM5300E AT Command Manual V1.02
+CME ERROR: <err>
Parameters <mode>
0 Not set detect PDP
1 Set detect PDP
<interval>
1<=interval<=180(s)
<timer>
1<=timer<=10
Reference
Note:
If "+PDP: DEACT" urc is reported because of module not attaching to
gprs for a certain time or other reasons, user still
"AT+CIPSHUT" command makes PDP context come back to original state.
7.2.23 AT+CIPMODE Select TCPIP Application Mode
AT+CIPMODE Select TCPIP Application Mode
Test Command
AT+CIPMODE=?
Response
+CIPMODE:(0-NORMAL MODE,1-TRANSPARENT MODE)
OK
Read Command
AT+CIPMODE?
Response
+CIPMODE: <mode>
OK
Write Command
AT+CIPMODE=<mode>
Response
OK
If error is related to ME functionality:
+CME ERROR: <err>
Parameters <mode>
0 Normal mode
1 Transparent mode
Reference
7.2.24 AT+CIPCCFG Configure Transparent Transfer Mode
AT+CIPCCFG Configure Transparent Transfer Mode
To Next Page
Loading...
Need help?
General
