SimCom SIM5300E

SIM5300E AT Command Manual V1.02
199
commands.
11.2.18 AT+FTPSTATE Get FTP Current State
AT+FTPSTATE Get FTP Current State
Test Command
AT+FTPSTATE=?
Response
OK
Execution Command
AT+FTPSTATE
Response
+FTPSTATE: <state>
OK
If error is related to ME functionality:
+CME ERROR: <err>
Parameters <state>
0 idle
1
in the FTP session, including FTPGET, FTPPUT, FTPDELE and
FTPSIZE operation.
Reference Note
11.2.19 AT+FTPEXTPUT Extend Upload File
AT+FTPEXTPUT Extend Upload File
Test Command
AT+FTPEXTPUT=?
Response
OK
Write Command
1)if mode is 0 or 1 or 2
AT+FTPEXTPUT=<mode>[,<pos
>,<len>,<timeout >]
2)if mode is 3
AT+FTPEXTPUT=<mode>,<file
name>
Response
If mode is 0 or 1
OK
If mode is 2
+FTPEXTPUT:<address>,<len>
…… //Input data
OK
If mode is 3 and file is exist in flash
OK
If error is related to ME functionality:
SIMCOM CONFIDENTIAL FILE