SIM5300E AT Command Manual V1.02
character strings correctly between the TE and ME character sets.
OK
If error is related to ME functionality:
+CME ERROR: <err>
Parameters <chset>
"GSM" GSM 7 bit default alphabet (3GPP TS 23.038);
"UCS2 "16-bit universal multiple-
octet coded character set
(ISO/IEC10646); UCS2 character strings are converted to
hexadecimal numbers from 0000 to FFFF; e.g.
"004100620063" equals three 16-bit characters with decimal
values 65, 98 and 99
"IRA" International reference alphabet (ITU-T T.50 )
"HEX" Character strings consist only of hexadecimal numbers from 00
to FF;
Reference
3GPP TS 27.007 [13]
3.2.13 AT+CSTA Select Type of Address
AT+CSTA Select Type of Address
Test Command
AT+CSTA=?
Response
+CSTA: (list of supported <type>s)
OK
Read Command
AT+CSTA?
Response
+CSTA: <type>
OK
Write Command
AT+CSTA=<type>
Response
OK
If <type> is not in the parameter range:
ERROR
Parameters <type> Current address type setting.T
ype of address octet in integer
format;
129 Unknown type
161 National number type
145 International number type
177 Network specific number
Reference
3GPP TS 27.007 [13]
Note:
The ATD Command overrides this setting when a number is dialed.
To Next Page
Loading...
