SIM5300E AT Command Manual V1.02
OK
Write Command
AT+CIPSPRT=<send prompt>
Response
OK
If error is related to ME functionality:
+CME ERROR: <err>
Parameters <send prompt>
A numeric parameter which indicates whether to echo
prompt ‘>’ after module issues AT+CIPSEND command.
0
It shows "send ok" but does not prompt echo ‘>’ when
sending is successful.
1
It prompts echo ‘>’ and shows "send ok" when sending is
successful.
2 I
t neither prompts echo ‘>’ nor shows "send ok" when
sending is successful.
Reference
7.2.19 AT+CIPSERVER Configure Module as Server
AT+CIPSERVER Configure Module as Server
Test Command
AT+CIPSERVER=?
Response
+CIPSERVER: (0-CLOSE SERVER, 1-OPEN SERVER),(1-65535)
OK
Read Command
AT+CIPSERVER?
Response
+CIPSE
RVER:
<mode>
[,<por
t>,<chan
nel id>,
<be
are
r>]
OK
Write Command
A
T+CI
PSER
VER=
<mode>,
<po
rt>
Response
OK
If error is related to ME functionality:
+CME ERROR: <err>
Parameters <mode>
0 Close server
1 Open server
<port>
1..65535 Listening port
To Next Page
Loading...
Need help?
General
