SIM5300E AT Command Manual V1.02
<PDP_type> (see +CGDCONT and command).
If a value is omitted for a particular class then the value is considered to be
unspecified.
Reference
6.2.14 AT+CGEQNEG 3G Quality of Service Profile(Negotiated)
AT+CGEQNEG 3G Quality of Service Profile (Negotiated)
Read Command
AT+CGEQNEG=?
+CGEQNEG: (list of <cid>s associated with active contexts)
OK
Write Command
AT+CGEQNEG
=[<cid>[,<cid>[,...]]]
+CGEQNEG: <cid>, <Traffic class> , <Maximum bi-trate UL>, <Maximum
bitrate DL> , <Guaranteedbitrate UL>, <Guaranteed bitrateDL>,
<Deliveryorder> ,<Maximum SDU size> , <SDU error ratio> ,<Residual bit
errorratio> , <Delivery of erroneous SDUs> , <Transfer delay> , <Traffic
handling priority>
[<CR><LF>+CGEQNEG: <cid>, <Traffic class> ,<Maximum bitrate UL>,
<Maximum bitrate DL> ,
<Guaranteed bitrate UL>, <Guaranteed bitrate DL>, <Delivery or
der> ,
<Maximum SDU size> , <SDUerror ratio> , <Residual bit error ratio> ,
<Deliveryof erroneous SDUs> , <Transfer delay> , <Traffichandling priority>
[....]]
OK
Parameters <cid>
a numeric parameter which specifies a particular PDP context definition (see
+CGDCONT and +CGDSCONT commands).
The following parameters are defined in 3GPP TS 23.107 [46]
<Traffic class>
a numeric parameter that indicates the type of application for which the
UMTS bearer
service is vailable. 0 conversational (default)
1 streaming
2 interactive
3 background
Other values are reserved.
<Maximum bitrate UL>
a numeric parameter that indicates the maximum number of kbits/s
To Next Page
Loading...
Need help?
General
