SimCom SIM5300E User Manual

SIM5300E AT Command Manual V1.02
142
ratio indicates the bit error ratio in the delivered SDUs. The value is specified
as 'mEe'. As
an example a target residual bit error ratio of 5.10-3 would be specified as
'E3' (e.g.
AT+cgeqreq=....,"5E3",...) (refer 3GPP TS 24.008 [8] subclause 10.5.6.5).
<Delivery_of_erroneous_SDUs>
A numeric parameter that indicates whether SDUs detected as erroneous
shall be
delivered or not.
0 no
1 yes
2 no detect
Other values are reserved.
<Transfer_delay>
A numeric parameter (0,1,2,...) that indicate
s the targeted time between
request to
transfer an SDU at one SAP to its delivery at the other SAP, in milliseconds
(refer 3GPPTS 24.008 [8] subclause 10.5.6.5).
<Traffic_handling_priority>
A numeric parameter (1,2,3,...) that specifies the relative importance for
handling of all SDUs belonging to the UMTS bearer compared to the SDUs of
other bearers (refer 3GPPTS 24.008 [8] subclause 10.5.6.5).
<Source_Statistics_Descriptor>
Supported in R7 P S a numeric parameter that specifies characteristics of the
so
urce of the submitted SDUs for a PDP context. This parameter should be
provided if the Traffic
class is specified as conversational or streaming (refer 3GPP TS 24.008 [8]
subclause
10.5.6.5).
0 Characteristics of SDUs is unknown (default value)
1 Characteristics of SDUs corresponds to a speech source
Other values are reserved.
<Signalling_Indication>
Supported in R7 P S a numeric parameter used to indicate confirmat content
of submitted SDUs for a PDP context. This parameter should be provided if
the Traf
fic class is specified as interactive (refer 3GPP TS 24.008 [8] subclause
10.5.6.5).
0 PDP context is notoptimized for confirmat (default value)
1 PDP context is optimized for confirmat
SIMCOM CONFIDENTIAL FILE

SimCom SIM5300E Specifications

General

Brand	SimCom
Model	SIM5300E
Category	Control Unit
Language	English