SimCom SIM5300E

SIM5300E AT Command Manual V1.02
153
Only send data at the status of established connection.
7.2.4 AT+CIPQSEND Select Data Transmitting Mode
AT+CIPQSEND Select Data Transmitting Mode
Test Command
AT+CIPQSEND=?
Response
+CIPQSEND: (list of supported<n>s)
OK
Read Command
AT+CIPQSEND?
Response
+CIPQSEND: <n>
OK
Write Command
AT+CIPQSEND=<n>
Response
OK
Parameters <n>
0 Normal mode –
when the server receives TCP data, it will
respond SEND OK.
1 Quick send mode – when the data is sent to module, it will
respond DATA ACCEPT:<n>,<length>, while not responding
SEND OK.
Reference
7.2.5 AT+CIPACK Query Previous Connection Data Transmitting
State
AT+CIPACK Query Previous Connection Data Transmitting State
Test Command
AT+CIPACK=?
Response
OK
Write Command
If in multi IP connection
(+CIPMUX=1)
AT+CIPACK=<n>
Response
+CIPACK: <txlen>, <acklen>, <nacklen>
OK
Execution Command
If in single IP connection
(+CIPMUX=0)
AT+CIPACK
Response
+CIPACK: <txlen>, <acklen>, <nacklen>
OK
Parameters <n> A numeric parameter which indicates the connection number
SIMCOM CONFIDENTIAL FILE