EasyManua.ls Logo

SimCom SIM5300E

SimCom SIM5300E
267 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
SIM5300E AT Command Manual V1.02
9
If connection successful and non-voice call.
CONNECT<tex
t> TA switches to data modeWhen TA returns to Command
mode after call release
OK
If successfully connected and voice call
Reference
V.2 5ter
Note:
This Command may be aborted generally by receiving an ATH
Command or a character during execution. The abort
ing is not
possible during some states of connection establishment such as
handshaking.
<text> output only if ATX<value> parameter setting with the
<value> >0
2.2.5 ATE Set Command Echo Mode
ATE Set Command Echo Mode
Execution Command
ATE<value>
Response
Th
is setting determines whether or not the TA echoes characters received
from TE during Command state.
OK
Parameter <value>
0 Echo mode off
1 Echo mode on
Reference V.25 te r
2.2.6 ATH Disconnect Existing Connection
ATH Disconnect Existing Connection
Execution Command
ATH
Response
Disconnect existing call by local TE from Command line and terminate call
OK
Reference V.25 te r
Note: OK is issued after circuit 109(DCD) is turned off, if it was previously
on.
2.2.7 ATI Display Product Identification Information
ATI Display Product Identification Information
SIMCOM CONFIDENTIAL FILE

Table of Contents

Other manuals for SimCom SIM5300E

Related product manuals