SimCom SIM5300E

SIM5300E AT Command Manual V1.02
189
Test Command
AT+FTPPORT=?
Response
OK
Read Command
AT+FTPPORT?
Response
+FTPPORT: <value>
OK
Write Command
AT+FTPPORT=<value>
Response
OK
If error is related to ME functionality:
+CME ERROR: <err>
Parameters <value> The value of FTP Control port, from 1 to 65535.
Default value is 21
Reference Note:
Numbers above 65535 are illegal as the port identification fields are 16
bits long in the TCP header.
11.2.2 AT+FTPMODE Set Active or Passive FTP Mode
AT+FTPMODE Set Active or Passive FTP Mode
Test Command
AT+FTPMODE=?
Response
OK
Read Command
AT+FTPMODE?
Response
+FTPMODE: <value>
OK
Write Command
AT+FTPMODE=<value>
Response
OK
If error is related to ME functionality:
+CME ERROR: <err>
Parameter <value>
0 Active FTP mode
1 Passive FTP mode
Reference
11.2.3 AT+FTPTYPE Set FTP Transfer Type
AT+FTPTYPE Set FTP Transfer Type
SIMCOM CONFIDENTIAL FILE