SimCom SIM5300E

SIM5300E AT Command Manual V1.02
131
AT+CGDATA =? +CGDATA: list of supported <L2P>s
OK
Write Command
AT+CGDATA=<L2P> [,<cid>]
Response
CONNECT
If error is related to ME functionality:
+CME ERROR: <err>
Parameters <L2P>
A string parameter (string should be included in quotation marks)
that indicates the layer 2 protocol to be used between the TE and MT:
"
PPP
"
Point to Point protocol for a PDP such as IPOther values are
not supported and will result in an ERROR response to the
execution Command.
<cid>
A numeric parameter which specifies a particular PDP context
definition (see +CGDCONT Command)
Reference
6.2.7 AT+CGPADDR Show PDP Address
AT+CGPADDR Show PDP Address
Test Command
AT+CGPADDR=?
Response
+CGPADDR: (list of defined <cid>s)
OK
Write Command
AT+CGPADDR=<cid>
Response
+CGPADDR: <cid>,<PDP_addr>
[<CR><LF>+CGPADDR: <cid>,<PDP_addr>[…]]
OK
If error is related to ME functionality:
+CME ERROR: <err>
Parameters
<cid>
A numeric parameter which specifies a particular PDP context
definition (see +CGDCONT Command)
<PDP_addr> String type, IP address
Format: "<n>.<n>.<n>.<n>" where <n>=0..255
SIMCOM CONFIDENTIAL FILE