SIM5300E AT Command Manual V1.02
delivered to UMTS(up-
link traffic) at a SAP. As an example a bitrate of 32
kbit/s would be specified as '32'(e.g. +CGEQNEG:...,32, ...) (refer TS 24.008 [8]
subclause 10.5.6.5).
<Maximum bitrate DL>
a numeric parameter that indicates the maximum number of kbits/s
delivered by UMTS(down-link traffic) at a SAP As an example a bitrate of 32
kbit/s would be specified a
s'32' (e.g. +CGEQNEG:...,32, ...) (refer TS 24.008 [8]
subclause 10.5.6.5).
<Guaranteed bitrate UL>
a numeric parameter that indicates the guaranteed number of kbits/s
delivered to UMTS(up-
link traffic) at a SAP (provided that there is data to
deliver). As an example a bitrate of 32kbit/s would be specified as '32' (e.g.
+CGEQNEG: ...,32, ...) (refer TS 24.008 [8]subclause 10.5.6.5).
<Guaranteed bitrate DL>
a numeric parameter that indicates the guaranteed number of kbits/s
delivered by UMTS(down-link traffic) at a SAP (provided that there is data to
deliver). As an example a bitrate of 32 kbit/s would be specified as '32' (e.g.
+CGEQNEG: ...,32, ...) (refer TS24.008 [8] subclause 10.5.6.5).
<Delivery order>
a numeric parameter that indicates whether the UMTS bearer shall provide
in-sequence
SDU delivery or not
0 no
1 yes
Other values are reserved.
<Maximum SDU size>
a numeric parameter that (1,2,3,...) indicates the maximum allowed SDU size
in octets(refer TS 24.008 [8] subclause 10.5.6.5).
<SDU error ratio>
a string parameter that indicates the target value for the fraction of SDUs lost
or detected as erroneous. SDU error ratio is defined only for conforming
traffic. The value is specified as 'mEe'. As an example a target SDU error ratio
of 5.10-3 would
be specified as '5E3'(e.g. +CGEQNEG:....,"5E3",...) (refer TS
24.008 [8] subclause 10.5.6.5).
<Residual bit error ratio>
a string parameter that indicates the target value for the undetected bit error
ratio in
To Next Page
Loading...
Need help?
General
