SIM5300E AT Command Manual V1.02
the delivered SDUs. If no error detection is requested, Residual bit error ratio
indicates
the bit error ratio in the delivered SDUs. The value is specified as 'mEe'. As an
example a target residual bit error ratio of 5.10-3 would be specified as '5E3'
(e.g.
+CGEQNEG:...,"5E3",...) (refer TS 24.008 [8] subclause 10.5.6.5).
<Delivery of erroneous SDUs>
a numeric parameter that indicates whether SDUs detected as erroneous
shall be delivered or not.
0 no
1 yes
2 no detect
Other values are reserved.
<Transfer delay>
a numeric parameter (0,1,2,...) that indicates the targeted time between
request to
transfer an SDU at one SAP to its delivery at the other SAP, in milliseconds
(refer TS
24.008 [8] subclause 10.5.6.5).
<Traffic handling priority>
a numeric parameter (1,2,3,...) that specifies the relative
handling of all
SDUs belonging to the UMTS bearer compared to the SDUs of other bearers
(refer TS
24.008 [8] subclause 10.5.6.5 Revision 2.5,
Reference
To Next Page
Loading...
