SIM5300E AT Command Manual V1.02
<Guaranteed_bitrate_DL>:
a numeric parameter that indicates the guaranteed number of kbits/s
delivered by UMTS (down-link traffic) at a SAP (provided that there is data to
deliver). As an example a bitrate of 32kbit/s would be specified as '32' (e.g.
AT+CGEQMIN=...,32, ...) (refer 3GPPTS 24.008 [8] subclause 10.5.6.5).
<Delivery_order>
a numeric parameter that indicates whether the UMTS bearer shall provide
in-sequence SDU delivery or not.
0 no
1 yes
Other values are reserved.
<Maximum_SDU_size>
a numeric parameter (1,2,3,...) that indicates the maximum allowed SDU size
in octets(refer 3GPP TS 24.008 [8] subclause 10.5.6.5).
<SDU_error_ratio>
a string parameter that indicates the target value for the fraction of SDUs lost
or detected
as erroneous. SDU error ratio is defined only for conforming
traffic. The value is specified as 'mEe'. As an example a target SDU error ratio
of 5.10-
3 would be specified as '5E3'(e.g. AT+CGEQMIN=...,"5E3",...) (refer
3GPP TS 24.008 [8] subclause 10.5.6.5).
<Residual_bit_error_ratio>
a string parameter that indicates the target value for the undetected bit error
ratio in the delivered SDUs. If no er
ror detection is requested, Residual bit
error ratio indicates
the bit error ratio in the delivered SDUs. The value is
specified as 'mEe'. As an example a target residual bit error ratio of 5.10-3
would be specified as 'E3' (e.g. AT+CGEQMIN=....,"5E3",...) (refer 3GPP TS
24.008 [8] subclause 10.5.6.5).
<Delivery_of_erroneous_SDUs>
a numeric parameter that indicates whether SDUs detected as erroneous
shall be delivered or not.
0 no
1 yes
2 no detect
Other values are reserved.
<Transfer_delay>
a numeric pa
rameter (0,1,2,...) that indicates the targeted time between
request to
transfer an SDU at one SAP to its delivery at the other SAP, in milliseconds
To Next Page
Loading...
Need help?
General
