SIM5300E AT Command Manual V1.02
Parameters <n>
A numeric parameter which indicates whether to show the
+CSSI:<code1>[,<index>] result code p
resentation status after a mobile
originated call setup
0 disable
1 enable
<m> A numeric parameter which indicates whether to show the +CSSU:
<code2>[<index> [,<number>,<type>]]
+CSSU:<code2> result code presentation status during a mobile terminated
ca
ll setup or during a call, or when a forward check supplementary service
notification is received.
0 disable
1 enable
<code1>
0 Unconditional call forwarding is active
1 Some of the conditional call forwarding are active
2 Call has been forwarded
3 Call is waiting
4 This is a CUG call (also <index> present)
5 Outgoing calls are barred
6 Incoming calls are barred
7 CLIR suppression rejected
8 Call has been deflected
<index> Closed user group index
<code2>
0 This is a forwarded call(MT call setup)
1 This is a CUG call (also <index> present) (MT call setup)
2 Call has been put on hold (during a voice call)
3 Call has been retrieved (during a voice call)
4 Multiparty call entered (during a voice call)
5 Call on hold has been released (this is not a SS notification)
(during a voice call)
6
Forward check SS message received (can be received
whenever)
7
Call is being connected (alerting) with the remote party in
alerting
state in explicit call transfer operation (during a
voice call)
8 Call has been connected w
ith the other remote party in
explicit call transfer operation (also number and subaddress
parameters may be present) (during a voice call or MT call setup)
9 This is a deflected call (MT call setup)
To Next Page
Loading...
Need help?
General
