DocID13902 Rev 15 1116/1128
RM0008 Revision history
1120
20-Oct-2011 14
Changed references to Programming Manual from PM0042 to PM0075.
ADC:
Removed scan mode note from AWDIE in Section 11.12.2 on page 237
Updated Section 11.3.8: Scan mode on page 220 to refer to DMA use.
DMA:
Added TIM8 and TIM7 DMA2 requests in Table 79 on page 283
Updated Figure 48.
TIMERS:
Updated Figure 72: Update rate examples depending on mode and TIMx_RCR register
settings on page 305 and preceding paragraph.
GPIO:
Added footnote below Table 24: USARTs .
FSMC:
Updated SRAM/ROM transactions in Table 108
UpdatedSection 21.3.1: Supported memories and transactions on page 501
Updated Section 21.3: AHB interface on page 500
Added note below Figure 188 and Figure 190
Updated Section 21.5: NOR Flash/PSRAM controller on page 504
Updated DATAST in SRAM/NOR-Flash write timing registers 1..4 (FSMC_BWTR1..4) on
page 537
Updated para b) in General transaction rules on page 501
SDIO:
Updated Table 163: R4 response on page 593 and Table 165: R5 response on page 594
USB:
Changed max. avrg. USB suspend mode current to 2.5 mA in Section 23.
bxCAN:
Updated Section 24.4.2: Normal mode on page 649
I2C:
Updated note in Section 26.6.8: I2C Clock control register (I2C_CCR) on page 775
USART:
Removed reference to dedicated IrDA pins from Section 27.3: USART functional
description on page 780
DBG:
Updated REV_ID in DBGMCU_IDCODE on page 1076
Table 235. Document revision history (continued)
Date Revision Changes
To Next Page
Loading...
Need help?
General
