System
Dial Number Plan
4-16 Strata CIX Programming Vol.1 12/09
09 DR Override by SSD Enable DR Override by System Speed Dial.
Possible values:Enable (default) or Disable
10 Auto Station Release Enable Automatic Station Release - when the other party disconnects the
station is automatically set to idle.
Possible values:Enable (default) or Disable
11 ISDN SPID Enable Auto Service Profile Identifier (SPID).
Possible values:Operable or Not Operable (default)
12 Night Mode Relay Assign BIOU Relay as the Night Relay. This relay activates when the
system is in the Night Mode.
Possible values:0~8 (default = 0)
BIOU1 provides relays 1 to 4; BIUO2 provides relays 5 to 8
Note CIX100 (ACTU) and CIX200 (LCTU): The built-in relay is
programmed as relay 5. For this operation, in Program 100 the
BIOU2 must be installed in Cabinet 2, Slot 5, PCB code 20.
13 BGM External Paging Set the External Page Group Number that includes the external paging
zones to which BGM will be sent. See Program 503.
Possible values:0~4 (CIX100)
0~8 (CIX200)
0~16 (CIX670)
0~24 (CIX1200
(default = 0)
14 Lost Call Destination Enter Lost Call Destination. Any valid DN such as PDN, PhDN or Pilot DN.
Possible values:Any DN (Up to 5 digits) (default = no value)
15 COS Override Code Class of Service Override Code Digits (1-8 digits). The digit length of COS
override codes. COS override codes are set in Program 510.
Possible values:1~8 (default = 1)
16 Multi-Conference Enable Multi-Conference capabilities for Analog Internal Calls and Outgoing
Calls.
Possible values:Enable or Disable (default)
17 Caller Number
Display
Enable Calling Number Display. If a soft key display competes with a Caller
ID, the Caller ID displays if enabled. Otherwise, the soft key function will
continue to be displayed.
Possible values:Enable (default) or Disable
F
IELD DESCRIPTION
To Next Page
Loading...