IP Telephone Programming
IP Mobility Programming
8-30 Strata CIX Programming Vol.1 12/09
IP Mobility Programming
Requirements
• CIX Software: R5.10 or higher
• SoftIPT: 02.00.0000 or higher
• MIPU: MIPU_01_01 or higher
• GIPH: GIPH_02_03 or higher
• GIPU8
• LIPU: LIPU_02_03 or higher
• Network eManager
• IPT20X0-SD: DIP2T2K
• IPT2008: DIP2M2K
• IPT2010: DIP2T2KX-A06
• IP5000
Note IP User Mobility will run on an MIPU/GIPU and an LIPU version LIPU_02_03 or higher. IP Mobility is
not supported on the BIPU.
More IP Telephone DNs than xIPU ports
In R5 and later, software administrators are able to create more IP telephones in Program 260 than the
number of xIPU ports.
When an IP telephone DN is programmed (Prog. 260) as Fixed Assignment it is registered to an available
xIPU resource. The xIPU resource must be available when the DN is programmed. When the IP telephone
DN is in use it will use that xIPU port. When logged out the xIPU port is held for that IP telephone DN. If an
xIPU resource is not available the IP telephone DN cannot be programmed. IP licenses are not checked
when the DN is programmed.
When an IP telephone DN is registered by Program 260, field 02 as Auto Assignment there is no specific
xIPU resource assigned and the number of licenses is not checked. This means there can be more IP
telephone DNs programmed into the CIX data base than there are xIPU resources. Also, there can be
more IP telephone DNs than IP port licenses.
To Next Page