Strata CIX 100 - Auto-Programming Limitations

Strata CIX Programming Guidelines
Use Default Auto-programming to Start Up
1-2 Strata CIX Programming Vol.1 12/09
Auto-programming Limitations
The following are the limitations of Strata CIX auto-programming.
• CTI programs are not programmed automatically.
• Strata CIX cannot configure unique LAN requirements automatically. Strata CIX’s LAN system data,
CIX IP address and Community Name are set to a default.
Note DND is only assigned on 20-button telephones.
• When the system is initialized, it takes a few minutes to recognize the mounted hardware.
• The Primary DN on the first button and DND on the last button are assigned telephone buttons; all other
buttons are not assigned automatically.
• In the Strata CIX100, CIX670 or CIX1200 Slot 0101 must always have a BDKU, ADKU or PDKU. The
BDKU is assigned if no PCB is installed.
• In the Strata CIX200 Slot 0101 must always have an MIPU, LIPU, BDKU or PDKU. An xIPU is assigned
if no PCB is installed, however no stations are assigned. R5 software assigns an MIPU; R4 software
assigns an LIPU.
Station and BIOU Auto-programming
Table 1-1 shows the Station and BIOU PCBs that will be recognized and set in Program 100 during auto-
programming.
Note No special assignments are set for BIOU/LIPU/MIPU/GIPU during auto-programming.
Table 1-1 Auto-Programming for Station and BIOU PCB Recognition (Program 100)
PCB Code PCB Name PCB Circuit Type
Parameter
Setting
Comments
000 No PCB or RRCU None or Remote Cabinets
002 RSTU 8 standard telephone
circuits
Standard telephone - no VM interface
settings
003 PDKU2 8 digital telephone PCM
Highway: 8
DKT2000 or DKT3000/3200 without
S-OCA (DKT3000 limitations: DKT2000, 16
character LCD display on DKT3000,
DKT3000/3200 LCD Feature key does not
function, DKT3014 large screen LCD does
not display).
004 Not used Not used
017 BDKU 8 digital telephones 8, 1B circuits DKT2000 or DKT3000/3200 without S-OCA
018 BDKU1+BDKS 16 digital telephones 16, 1B
circuits
DKT2000 or DKT3000/3200 without S-OCA
019 BIOU Page/MOH/Relay
interface#1
No functions assigned
020 BIOU2 Page/MOH/Relay
interface#2
No functions assigned. Strata CIX100
assigns a virtual BIOU2 into a virtual
location, Cabinet 02, Slot 05, to provide
control of the ACTU relay.