Operation
System Setup
Strata CIX Programming Vol.1 12/09 10-3
Operation
901 CTX/CIX Version And Processor Hardware
Prerequisite Program: None
Select Maintenance > Hardware Info. and Control - CIX Processor.
This program enables you to view the Active and Standby software versions installed on the Strata CIX
system processor.
915 Regional Selection
Prerequisite Program: None - Perform this program before doing any database programming.
1. Select Maintenance > Hardware Info. and Control - CIX Processor.
This program enables you to select the region for specific parameter operation.
Important! The region change does not take affect until the system has been initialized. This Level-
1initialize (Prog 900) will disable any database programming already in place.
F
IELD DESCRIPTION
System Type Displays the system type that is connected.
Possible values:CIX1200, CIX670, CIX200, CIX100 (Active only).
Active Software Displays the software versions.
These fields indicate the following:
A = Indicates software for USA, Canada or Mexico.
Rx.xx = Indicates the CIX release level.
M0011.00 = The software version number.
Note The Active software does not always have to be the same as the
Standby software, although the Active and Standby software versions
may be the same when you receive it from Toshiba.
Standby Software
DTMF, BBMS, BEXS,
BSIS, Ethernet,
Modem, DREC
Version, IPL Version
The check marks in these boxes indicate the hardware that is installed on the
Strata CIX processor.
On the CIX100:
• Ethernet means AETS is installed on ACTU.
• Modem means AMDS is installed on ACTU.
• DTMF means ARCS is installed on ACTU.
• Indicates the DTMF/ABR software.
• Indicates basic boot-up software version.
F
IELD DESCRIPTION
Region Select Region.
Possible values:
USA Singapore
Canada Malaysia
Mexico Indonesia
Taiwan Sri Lanka
Hong Kong Thailand
China Japan
UK Australia
To Next Page