Strata CIX 100 - Ip Mobility Programming Steps

IP Telephone Programming
Feature Administration/Programming
8-32 Strata CIX Programming Vol.1 12/09
IP Mobility Programming Steps
The basics of IP Mobility setup are done in the station assignment programming. The IP Mobility features
are assigned to directory numbers (DN). The steps below outline the process.
1. Assign the MIPU/GIPU/LIPU card.
2. Assign the DN that will use IP Mobility as an IPT. In program 260:
• field 01 –set to IPT
• field 49 – is a password required?
Disable (default) - no password required
Enable - a password is required to login. Set the password in field 43
• field 43 – The security code entered here is the IP Mobility login password when field 49 = Enable
• field 50 – Use Transfer Registration
Enable = IP Mobility
Disable = This DN does not have IP Mobility
• field 51–Read-Only field. Displays the MIPU/GIPU/LIPU equipment number for this DN.
3. For multi-node systems, assign the IP Address of the MIPU/GIPU/LIPU card in each node. Use
Network eManager Strata Net > Remote Node IPU Address. These assignments must be made in all
nodes.
Compatibility
IP User Mobility is compatible with the following:
• LIPU/LIPS (LIPU_02_03 and later)
• GIPH
• GIPU8
• MIPU16
• MIPU24
IP Mobility is not supported on the BIPU.
Terminal Information
SELECT=2, field 27
Language Mode
US English, UK
English, French/
Spanish
US
English
The IPT2008-SDL and IP5131-
SDL have language change
capability
Upper: IPT2010, 2020, IP5122-
SD, 5122-SDC, 5132-SD
Parameter Name Range Default
Used
Function
Lower: IPT2008, IP5131-SDL