Station
Assignment
5-8 Strata CIX Programming Vol.1 12/09
49 IP Phone Login Password Whether or not to apply the Login Password Authentication - Uses the
Personal Password (43)
Possible values:Enabled or Disabled (Default)
50 Transfer Registration Whether or not to apply Transfer Registration - Set to Enable to allow IP
Mobility for this DN.
Possible values:Enabled or Disabled (Default)
Note Assign a “Phone Logout” feature key on this DN.
51 Station Connecting
Equipment
Enter the PDN equipment number (0000 means auto assignment).
• IPT1020-SD must be installed on BIPU-M; IPT1020 cannot be installed on
LIPU/LIPS, MIPU or GIPx.
• SIP phones must be installed on LIPU/LIPS, MIPU or GIPx; SIP phones
cannot be installed on BIPU-M
• IPT2000 series and IP Softphones can be installed on LIPU/LIPS, MIPU,
GIPx or BIPU-M (see Prog 260 for LIPU/LIPS, MIPU or GIPx PDN
assignments). MIPU and GIPU require R5.0 software or higher.
Cabinet numbers:
• CIX100: Base, Exp.01
• CIX200: Base 01, Exp.02
• CIX670: Base 01, Exp 02~07.
• CIX1200: Base 01, Exp 02~12
Slot numbers:
• CIX100: Base 01, Exp.05~08
• CIX100: ACTU Relay Equipment= Cab 02, Slot 05.
• CIX100: ASTU Equipment=010901 and 010902
• CIX200: Base/Exp.01~04
• CIX200: LSLU Equipment=010401 and 010402.
• CIX670/1200: Base 01~08
• CIX670/1200: Exp.01~10
CTX28 and CIX40 assignments below are hard coded and cannot be
changed.
01, 05 – GVMU - 28, GVPH - 40 R1HW, GIPx, MIPU or GCOCIH - 40 R2HW
01, 06 – GIPx, MIPU16 or GCOCIH - 40 R1HW, no card - 28, 40 R2HW
52 Simple System SpeedDial Whether or not to system speed dial supplement is allowed.
Possible values:Enabled or Disabled (Default)
53 Analog Station
Disconnect Signal
Whether or not Analog Station Disconnect Signal is sent. Refer to “208 Timer”
on page 5-25.
Possible values:Enabled or Disabled (Default)
Table 5-1 Station Assignment Data for IP, and SIP Telephones (Prog 260) (continued)
To Next Page