Operation
License Control
Strata CIX Programming Vol.1 12/09 10-15
Operation
License Activate
Prerequisite Program: License Issue, above
This program enables activation of Network eManager licenses issued in License Issue.
License Information
The following programs enable you to set up Licensing details for Network eManager users.
Prerequisite Program: None
1. Select Mainteance > Licensing > License Information.
2. View Equipped License Information details for this Strata CIX account.
This view is read-only information.
F
IELD DESCRIPTION
Delay Timer Select Activation Delay Timer in hours.
Possible values:0~24 (default = 0)
Notes
• Enter 0 to issue or activate the license immediately or 1~24 to set the
automatic delay activation feature, where 1 = 1 hour delay; 2 = 2 hour delay,
etc.
• After the license is activated, use the License Information screen below to
check that all ports and features have been activated properly.
F
IELD DESCRIPTION
CIX/CTX Release
Number
This is the Basic Release Number of CIX software. To view the Active Software
Version, go to Operations/System Setup.
System Type This identifies the type of CIX system to which Strata eManager is currently
connected.
Maximum Number
of Cabinets
This identifies the maximum number of cabinets. The total of base plus
expansion cabinets.
Number of Serial
Ports
This identifies the number of serial ports licensed on the BSIS.
One license is needed for each SMDR and SMDI device connected to BSIS.
(Programs 803 and 804 assigns BSIS ports).
Number Of DTMF
Receivers
This identifies the number of DTMF receivers licensed. The ARCS
Subassembly is required on the CIX100 processor, no additional hardware is
required for CIX670 or CIX1200.
To Next Page