Strata CIX 100 - Disa Security Code

Trunks
Service
6-22 Strata CIX Programming Vol.1 12/09
Service
Program Number(s): 311 and 319
These commands assign Direct Inward System Access (DISA) properties.
1. Select > Trunk > Service.
2. Enter Program 311 data.
3. Enter Program 319 data.
4. Get Default - restores data to factory defaults.
5. Click Submit.
311 DISA Security Code
Prerequisite Program: None
Assigns DISA parameters.
F
IELD DESCRIPTION
01 DISA Enabled Enable DISA security code.
Possible values:Enable or Disable (default)
02 DISA Code Enter DISA security code. Only required if DISA Security Code is marked
as necessary.
Possible values:Up to 15 digits (default = no value)
03 Response Timer Choose the time, in seconds, the CIX will wait before answering an
incoming DISA call.
Possible values:0~30 (default = 5)
04 Idle Timer Choose the time, in seconds, the CIX will wait for the first DTMF tones after
answering a DISA call.
Possible values:0~60 (default = 10)
05 Tie Line Access Enable this feature to allow DISA callers to access Tie lines when they call
into the system.
Possible values:Enable or Disable (default)