Services
Strata CIX Programming Vol.1 12/09 9-3
Services
579 System Voice Mail Data
Prerequisite Program: None
This command assigns DTMF/SMDI Voice Mail interface parameters for the system.
1. Select > System > Voice Mail Data.
2. Enter Program 579 data.
3. Get Default - sets all values to factory defaults.
4. Click Submit.
F
IELD DESCRIPTION
01 DID/DNIS or DN VMID
Option
Select DN VMID to send the DN's VMID to voice mail on DID/DNIS calls that are
answered and then transferred to a DN which then forwards to voice mail.
Select DID/DNIS VMID to send the DID/DNIS number's VMID to voice mail on DID/
DNIS calls that are answered and then transferred to a DN which then forwards to
voice mail.
Possible values: Before Answer Only (default), Before and After.
If a DID/DNIS call is answered by a station and then transferred to a DN which then
forwards to voice mail, the VMID of the DID/DNIS number (Program 309, field 11 or
field 15) or the VMID of the forwarding DN (Program 200, field 19 or 206, field 06) will
be sent to voice mail per this option.
Note The DID/DNIS number's VMID (Prog 309, 11 or 15) is always sent to
voice mail on DID/DNIS calls that ring directly to voice mail or ring a
DN which then forwards to voice mail before it is ever answered.
02 Cancellation Method
for VM MW
Select the method used to cancel voice mail message waiting indication.
Possible values:Auto and Access Code Cancel or Access Code Cancel (default)
03 Message Desk
Number
Enable sending of the SMDI Message Desk Number (001) in the SMDI packet;
otherwise 000 for a station call or the 3-digit CO line number is sent.
Possible values:Enable or Disable (default)
04 Output of CLASS /
ANI and DNIS
Enable including Caller ID/ANI numbers in SMDR records.
Possible values:Enable or Disable (default)
05 Calling Number Digits
Sent to VM
Choose how many calling number digits are sent to VM unit.
Possible values:2~10 digits (default = 10)
Note If 04 Output of CLASS / ANI and DNIS is enabled this value must be 10.
06 Blank Digits Sent to
VM
Select SMDI-Bellcore Standard VM Interface.
Possible values:1 or 2 (default) - 1 = 1985 (single space), 2 = 1991 (two spaces)
07 Auto Cancel of VM
and MW
Setting of auto cancel of VM and MW (this function is not currently supported).
Possible values:Enable (default) or Disable
08 DTMF Duration Select VM ID Code and System DTMF Signal Time.
Possible values:80 ms (default) or 160 ms
To Next Page