Strata CIX 100 - Network Jack Lan Device Assignment

To Next Page

To Previous Page

System

Miscellaneous System Commands

Strata CIX Programming Vol.1 12/09 4-39

System

801 Network Jack LAN Device Assignment

Prerequisite Program: 803 on page 4-36.

This assigns Strata CIX LAN parameters, enabling PC applications to connect to the BECU network jack.

1. Select > System > I/O Device.

2. Click the LAN Device tab.

3. Enter Program 801 data. Refer to Table 4-4 on page 4-40

4. Get Default sets all values to factory default.

5. Click Submit.

IELD DESCRIPTION

00 LAN Port Index No. Enter the port number of the LAN device to be assigned or select from the

list. Refer to “803 Application Port Assignments” on page 4-36.

Possible values:1~12 (default = no value)

01 Protocol Select Communication Protocol.

Possible values:TCP (default) or UDP

Note Select UDP for Network DSS and TCP for CIX applications.

02 Application Type Select the Operation Type.

• If Server is selected, make an entry in 04 Server Port Number.

• If Client is selected, make an entry in 05 Client IP Address.

Possible values:Server (default) or Client

03 Data Flow Select the data flow protocol for CIX and PC communications.

Possible values:Synchronous or Asynchronous (default = Asynchronous)

04 Server Port No. Enter the Server Port Number and proceed to 07 Read Retry Number. This

field is required if Server was selected in 02 PC Operation Type above. If not,

leave this field blank and proceed to 05 Client IP Address.

Possible values:0~65535 (default = 0)

05 Client IP Enter the Client LAN IP Address. This field is required if Client was selected

in 02 PC Operation Type above.

Possible values:0~255 for each octet (default = 0)

06 Client Port No. Enter the Client Port number

Possible values: 0~65535 (default = 0)

For Central LAN SMDR in a Strata Net use the same port number if the

SMDR Application supports receiving data from multiple nodes on one port

(i.e. 6000). Use a unique port number in each node if the SMDR Application

does not support receiving data from multiple nodes on a single port (i.e.

Node 1=6000, Node 2=6001). Refer to Figure 4-1 on Page 4-40.

07 Read Retry No. Set the maximum number of Read Retries.

Possible values: 0 ~ 10 (default = 1)