Strata CIX 100 - Page 260

To Next Page

To Previous Page

Trunks

6-6 Strata CIX Programming Vol.1 12/09

06 Pooled Key1 Number Select first Pooled Line Key Group number.

Possible values:1~6 CTX28, 1~32 CIX40, 1~32 CTX/CIX/100, 1~50 CTX/CIX 670

BCTU only or BBCU only, 1~128 CTX/CIX670 BCTU + BEXU or

BBCU + BECU, 1~50 CIX1200 HCTU only, 1~128 CIX1200 HCTU

+ HEXAU, 1~220 CIX1200 HCTU + HEXBU

(default = no value)

07 Pooled Key2 Number Select second Pooled Line Key Group number.

Possible values:1~6 CTX28, 1~32 CIX40, 1~32 CTX/CIX/100, 1~50 CTX/CIX 670

BCTU only or BBCU only, 1~128 CTX/CIX670 BCTU + BEXU or

BBCU + BECU, 1~50 CIX1200 HCTU only, 1~128 CIX1200 HCTU

+ HEXAU, 1~220 CIX1200 HCTU + HEXBU

(default = no value)

08 COS Select Day 1, Day 2 and Night Values.

Possible values:1~32 (default = 1)

09 FRL Select Day 1, Day 2 and Night Values.

Possible values:1~16 (default = 1)

10 QPL Select Day 1, Day 2 and Night Values.

Possible values:1~16 (default = 1)

11 Speech/3.1 KHz Bearer Capability 3.1 KHz Audio or Speech.

Possible values:Audio (default) or Speech

12 MOH Source Select MOH Source.

Possible values:Silence, External1~15, Internal (default)

13 Account Code Whether or not Forced Account Code is applied when using this OLG.

Possible values:Enable or Disable (default)

14 Destination

Restriction

Whether or not Destination Restriction is applied when using this OLG.

Possible values:Enable or Disable (default)

15 Credit Cart Calling Whether or not to enable Credit Card Calling using this OLG.

Possible values:Enable or Disable (default)

16 Send CESID Whether or not E911 CESID information is sent (enabled) on this OLG.

Possible values:Enable or Disable (default = Disable)

17 QSIG Sending Type Digit sending mode for Strata Net only.

Possible values:Cut Through or Senderized (default = Cut through)

18 Network COS Select Network COS number.

Possible values:1~32 (default = 1)

19 Recall on AC15 This enables or disables the sending and detection of a recall signal on AC15 TIE

lines. (This applies to the PACU PCBs only.)

Possible values: Enable of Disable (default = Disable)

IELD DESCRIPTION