IP Telephone Programming
IP Telephone Installation and Network Connection Setup
8-12 Strata CIX Programming Vol.1 12/09
07 Packet Loss Threshold If packet loss is more than 10, an error is recorded in the CIX error log and you
cannot talk by IP telephone. The default value 5 is recommended.
Possible values:0, 5, 10
08 Transmission Interval
for MIPU/GIPU
10 ms
20 ms (default)
30 ms
40 ms
80 ms (only when G.729A is assigned; 40ms when G.711 assigned)
09 Jitter Buffer Type for
MIPU/GIPU
Fixed
Adaptive (default)
Relative to FK02.
10 Jitter Buffer Length for
MIPU/GIPU
0 to 200 ms (default = 100 ms)
Corresponding to FK03
11 Maximum Acceptable
Jitter Buffer for MIPU/
GIPU
10 to 400 ms (default = 200 ms)
Corresponding to FK04
12 Packet Loss Ratio for
MIPU/GIPU
0 to 10% (default = 5%)
Corresponding to FK06
13 Packet Loss Threshold
for MIPU/GIPU
0 to 10% (default = 1%)
Corresponding to FK07
F
IELD DESCRIPTION
To Next Page