Services
External Devices
Strata CIX Programming Vol.1 12/09 9-51
Services
03 DDCB Equipment No. Enter the DDCB equipment number to which the door lock should be assigned.
This is the cabinet, slot, and circuit number of the BDKU/BDKS or PDKU interface
PCB to which the DDCB is to be connected.
Enter data as XXYYZZ:
XX=cabinet 01~12
YY=slot 01~10
ZZ=circuit 01~16
Example: If the DDCB interface should be connected to a ADKU, PDKU, BEDKU,
or BDKU/BDKS in cabinet shelf 5, slot 2, circuit 3, enter 050203.
Note Note: If a PDN is assigned to the DDCB equipment number it must
be deleted, using PRG201, before attempting to assign the DDCB
console.
Cabinet numbers:
• CIX/CTX100: Select 01 for Base and Expansion cabinet.
• CIX200: Select 01 for Base and 02 for Expansion cabinet.
• CIX/CTX670: Select 01 for Base and 02~07 respectively for each
Expansion cabinet.
• CIX1200: Select 01 for Base and 02~12 respectively for each
Expansion cabinet.
Slot numbers:
• CIX/CTX100: Select 01~04 for Base slots and 05~08 for Expansion
slots.
• CIX/CTX100: Virtual Slot for ACTU Relay = Cabinet 02, Slot 05.
• CIX200: Select 01~04 for either cabinet.
• CIX/CTX670: Select 01~08 for Base slots and 01~10 for Expansion
slots.
• CXI1200:Select 01~08 for Base slots and 01~10 for Expansion slots.
• CTX28 and CIX40 assignments are hard coded cannot be changed.
• Virtual Slot for GCTU Relay = Cabinet 02, Slot 05.
01, 01 - 8 digital telephones on motherboard (CTX28, CIX40 R1HW and R2HW).
01, 02 - 3 CO lines on motherboard (CTX28, CIX40 R1HW), 4 CO lines (CIX40
R2HW)
01, 03 - no card (CTX28, CIX40 R1HW), GVPH (CIX40 R2HW)
01, 04 - 1 (Base) or 2 (GSTU) analog station ports (CTX28, CIX40 R1HW and
R2HW)
01, 05 - GVMU (CTX28), GVPH (CIX40 R1HW), GIPx, MIPU or GCOCIH (CIX40
R2HW)
01, 06 - GIPx, MIPU16 or GCOCIH (CIX40 R1HW), no card (CTX28, CIX40 R2HW)
01, 07 - 8 digital telephones on GCDU (CTX28, CIX40 R1HW and R2HW).
01, 08 - 3 CO lines on GCDU (CTX28, CIX40 R1HW and R2HW).
F
IELD DESCRIPTION
To Next Page