General measurement settings: Start Delay, Start Sync.,
Integration Period Inf., Integration Period, Repetition
Cycles, RMS Integration, Day Time Limits and
Rolling Time.
Delay between pressing the <Start> key and the start of
measurement integration.
Synchronization of the measurement/integration start to
the nearest full minute or hour of the instrument real-time
clock. It helps to measure in full cycles.
Infinitive averaging of Summary Results that lasts from
start of the measurement till its cancellation with the
<Stop> key or remotely.
Maximum number of logger files if integration period is
infinite.
Time of averaging of Summary Results: from 1 second
to Infinitive. For example, with 8 hours integration period
the LEQ result will be averaged for 8 hours. In case of
Infinitive, the measurement will last until the user presses
the <Stop> key.
Number of measurement/integration repetitions after the
<Start> key pressure.
This enables to make a series of measurements without
pressing the <Start> key and save this series in the
results file.
Type of integration of RMS based results (RMS
detector): Linear or Exponential. The IEC 61672-1:2013
standard requires Linear integration, without time
weighting, however in some countries old regulation
refers to the Exponential RMS integration with standard
time weighting: Fast or Slow.
Linear type of integration of RMS based results (RMS
detector), without time weighting according to the
IEC 61672-1:2013 standard.
To Next Page
Loading...
