Standard according to which STIPA averages will be
performed in the automatic mode: IEC 60268-16x2 or
IEC 60268x3.
Results to be displayed: STI or CIS.
Adjustment of the reference STIPA signal level to the
level of a real voice signal in the tested area.
Screen that enables setting the ambient noise distortions
in the way of sound pressure in the 1/1-octave bands with
central frequencies from 125 to 8000 Hz. This screen is
connected with the STIPA function.
Instrument's function, enabling alarm setting, generation
and alerting. The alarm setting can be done through the
SvanPC++ software. If Alarms were defined the they can
be seen in the instrument's screens. Some terms, used
in the SvanPC++ software, are presented below:
List of alarm conditions. Alarm condition can be a
Threshold or Time type.
Alarm condition type. Alarm is generated if the selected
result (Leq, Lpeak, Lmax, Lmin or sliding Leq for screens
of 15 or 60 minutes) exceeds the threshold level.
Alarm condition type. Alarm is generated in the selected
days of the week and during the defined time period.
Event that generates alarm based on combination of
Threshold and Time conditions. For each event, a
different type of Action can be set.
To Next Page
Loading...
