Svantek SVAN 979 - Page 230

230
SVAN 979 User Manual - Appendixes
7
FirmwareBetaSubVer
additional internal software upgrade number for Beta version;
number is relevant only if the internal software upgrade is zero; for
example, Beta version is 3.21.06
8
FirmwareDate
internal software date
9
FileSysVersion
version number of the result files system; for example, 321 means
version 3.21
…
reserved
Table B.1.4. Information about calibration
Word
number
Name
Comment
0
0nn47h
47h = block identifier
0nnh = block length in words
1
PreCalibrType
calibration type:
0 – no calibration
1 – calibration By Measurement
2 – calibration By Sensitivity
3 – factory calibration
2
PreCalibrDate
date of the calibration “Pre" (parameter important only for the
performed calibration)
3
PreCalibrTime
hour of the calibration “Pre" (parameter important only for the
performed calibration)
4
PreCalibrFactor
calibration “Pre" factor in 0.01 dB format (parameter important only
for the performed calibration)
…
reserved
Table B.1.5. User’s text
Word
number
Name
Comment
0
0nn03h
03h = block identifier,
0nnh = block length in words
1..
TitleText
comment text; ASCII character row (terminated by zero byte)
Table B.1.6. Information about the instrument name
Word
number
Name
Comment
0
0nn58h
58h = block identifier
0nnh = block length in words
1
UnitNameID
instrument name identifier (text "UN")
2..
UnitName
ASCII character row (terminated by zero byte) specifying the
instrument name
…
reserved
Table B.1.7. Measurement parameters
Word
number
Name
Comment
0
0nn04h
04h = block identifier
0nnh = block length in words