Svantek SVAN 979 - Page 231

231
SVAN 979 User Manual - Appendixes
Word
number
Name
Comment
1
MeasureStartDate
start date of the measurement
2
MeasureStartTime
start time of the measurement
3
DeviceMode
measurement mode:
0 – vibration measurement mode,
1 – sound measurement mode,
4
DeviceFunction
measurement function
1 – Level Meter
2 – 1/1 Octave
3 – 1/3 Octave
5 – Loudness
6 – FFT
7 – Tonality
8 – RT60
15 – 1/6 Octave
16 – 1/12 Octave
19 - STIPA
5
MeasureInput
measurement Input type:
2 – measurement with the microphone
5 – measurement with the vibration accelerometer
6
Range
measurement range:
1 – Low
2 – High
7
StatDet
for sound measurement mode:
0 – measurement of statistical results with the linear detector
1 – measurement of statistical results with the exponential
detector
8
RepCycle
number of measurement cycles (zero means infinity) - the parameter
is important if the duration of the measurement cycle (IntTimeSec) is
finite; for infinite measuring cycle time this parameter is irrelevant
(see SplitCycles)
9
NofProf
number of measurement profiles
10
StartDelay
measurement start delay in seconds
11..12
IntTimeSec
duration of one measurement cycle in seconds (zero means infinity)
13
StartSync
measurement start synchronization:
0 – no synchronization,
-1 – synchronization to full second
1 – synchronization to full minute
15 – synchronization to full 15 minutes
30 – synchronization to full 30 minutes
60 – synchronization to full hour
14
RmsInt
detector type for RMS/Leq results:
0 – measurement with linear detector
1 – measurement with exponential detector
15
SpecLogg
bit mask of logged spectra results:
8 – RMS/Leq spectrum (applies to octave spectra)
8 – average spectrum (applies to FFT spectrum)
the remaining masks are reserved