Teledyne API T703/T703U Calibrator Operation Manual Communications
117
5.7. APICOM REMOTE CONTROL PROGRAM
APICOM is an easy-to-use, yet powerful interface program that allows the user to
access and control any of Teledyne API‟s main line of ambient and stack-gas
instruments from a remote connection through direct cable, modem or Ethernet.
Running APICOM, a user can:
Establish a link from a remote location to the T703 through direct cable
connection via RS-232 modem or Ethernet.
View the instrument‟s front panel and remotely access all functions that could
be accessed when standing in front of the instrument.
Remotely edit system parameters and set points.
Download, view, graph and save data for predictive diagnostics or data
analysis.
Retrieve, view, edit, save and upload DAS configurations.
Check on system parameters for trouble-shooting and quality control.
APICOM is very helpful for initial setup, data analysis, maintenance and trouble-
shooting. Figure 5-5 shows examples of APICOM‟s main interface, which
emulates the look and functionality of the instruments actual front panel
Figure 5-5: APICOM Remote Control Program Interface
NOTE
APICOM is included free of cost with the calibrator and the latest versions can also be
downloaded for free at http://www.teledyne-api.com/software/apicom/.
The T703 calibrator is fully supported by APICOM revision 3.9.4 and later.
Instruments with the LEADS support option must run APICOM revision 4.0 and later
To Next Page
Loading...