TELEDYNE API T703U - Using the Internal Clock to Trigger Sequences

Operating the Calibrator Teledyne API T703/T703U Calibrator Operation Manual
50
Using the Internal Clock to Trigger Sequences 4.5.1.4.
Sequences can be set to trigger based on the internal clock. The sequence can be
set up to start at a predetermined date and time. It can also be set to repeat after a
predetermined delay time.
So activate and sequence timer, press:
STANDBY ACT =STANDBY
<TST TST> GEN STBY SEQ SETUP
Make sure that the
calibrator is in standby
mode.
SETUP X.X PRIMARY SETUP MENU
O3 SEQ CFG CLK PASS MORE EXIT
SETUP X.X SEQUENCE CONFIGURATION
EDIT PRINT EXIT
SETUP X.X END OF SEQUENCES
INS PRNT EXIT
SETUP X.X 1) SEQ [NAME], [X] STEPS
PREV NEXT INS DEL EDIT PRNT EXIT
SETUP X.X NAME:0
SET> EDIT EXIT
Deletes the sequence shown
in the message field
Edits the sequence shown
in the message field
Scrolls back and forth between
existing sequences
SETUP X.X TIMER ENABLE:DISABLED
<SET SET> EDIT EXIT
Continue pressing SET> until ...
This display only appears if there are no sequences currently
programmed into the calibrator.
OTHERWISE ...
EXIT discards the
new setting
ENTR accepts the
new setting
SETUP X.X TIMER ENABLE:OFF
OFF ENTER EXIT
Toggle to turn
Timer Enable
input ON/OFF
SETUP X.X TIMER ENABLE:ENABLED
<SET SET> EDIT EXIT
07223D DCN7107