Teledyne API T703/T703U Calibrator Operation Manual Getting Started
33
COMMUNICATION CONNECTIONS 3.2.6.
The T-Series instruments are equipped with connectors for remote
communications interfaces. This section describes those features.
Ethernet Connection 3.2.6.1.
For network or Internet communication with the instrument, connect an Ethernet
cable from the instrument‟s rear panel Ethernet interface connector to an Ethernet
port.
The T703 firmware supports dynamic IP addressing or DHCP (default setup) for
remote operation via an Ethernet connection. If your network also supports
DHCP, the calibrator will automatically configure its LAN connection
appropriately (see Section 5.6.1). If your network does not support DHCP, see
Section 5.6.1.1 for instructions on manually configuring the LAN connection.
USB Option Connection 3.2.6.2.
For direct communication between the instrument and a personal computer (PC),
connect a USB cable between the instrument and desktop or laptop USB ports. (If
this option is installed, the COM2 port can only be used for RS232 multidrop
communication). The Teledyne T-Series USB driver must be installed. See
Section 5.5.
RS-232 and RS485 Connection 3.2.6.3.
For RS-232 communications through the serial interface COMM ports, refer to
Section 5.1.1 of this manual for instructions on configuration and usage. For RS-
485 communication, contact the factory.
Multidrop Network Connection 3.2.6.4.
If your unit has a Teledyne API RS-232 multidrop card (Option 62), see Section
5.3 for instructions on setting it up.
To Next Page
Loading...