STANDBY ACT =STANDBY
<TST TST> GEN STBY SEQ SETUP
Make sure that the
calibrator is in standby
mode.
SETUP X.X PRIMARY SETUP MENU
O3 SEQ CFG CLK PASS MORE EXIT
SETUP X.X SEQUENCE CONFIGURATION
EDIT
PRINT EXIT
SETUP X.X END OF SEQUENCES
INS
PRNT EXIT
SETUP X.X 1) SEQ
[NAME]
,
[X]
STEPS
PREV NEXT INS DEL EDIT PRNT EXIT
SETUP X.X NAME:0
SET> EDIT EXIT
Deletes the sequence shown
in the message field
Edits the sequence shown
in the message field
Scrolls back and forth between
existing sequences
Press SET> to scroll to each
component to be defined
This display only appears if there are no sequences currently
programmed into the calibrator.
OTHERWISE ...
SETUP X.X NAME:[0]
CH> INS DEL [ 0 ] ENTR EXIT
To Next Page
Loading...