TELEDYNE API T703U - Activating a Sequence from the T703;T703 U Front Panel

Teledyne API T703/T703U Calibrator Operation Manual Operating the Calibrator
47
Activating a Sequence from the T703/T703U Front Panel 4.5.1.1.
To activate an already programmed sequence from the front panel, press:
Make sure that
the calibrator is in
STANDBY mode
STANDBY ACT =STANDBY
<TST TST> GEN STBY SEQ SETUP
STANDBY EXECUTE SEQUENCE:A1
PREV NEXT ENTR EXIT
Use these buttons
to scroll though
the list of available
sequences
[Progress Field] ACT CAL= 0.000LPM
<TST TST> GEN STBY SEQ SETUP
M703E begins to execute sequence
Progress of sequence
reported here in the
format chosen during
sequence entry.
At end of sequence progress report, the
calibrator remains in mode set by last
sequence instruction.
07223D DCN7107