1
Only appears when the
optional LEADS
software is installed.
EDIT
PRNTDELINSNEXTPREV
Cycles through list of
already programmed Levels
NOYES
SET><SET
Inserts a new Level Edits existing Level
EXIT
GENERATE GENERATE:ZERO
ZERO ENTR EXIT
GENERATE GENERATE:0 PPB O3
0 0 0 0 PPB O3 ENTR EXIT
PPB
MGM
UGM
PCT
PPT
PPM
Toggle to set the target concentration of the
calibrator output for this gas
Toggle to switch to O
3
generation
SETUP X.X [ACTION TO PERFORM]
PREV NEXT ENTR EXIT
MANUALGENERATE
SETUP X.X CAL GAS FLOW:0.0000 LPM
0 0 .0 0 0 ENTR EXIT
Toggle these keys to set the
calibration gas flow rate
SETUP X.X DILUENT FLOW:0.000 LPM
0 0 .0 0 0 ENTR EXIT
Toggle these keys to set the calibration gas flow rate
SETUP X.X O3 GEN SET POINT: 000.0 MV
0 0 0 0 .0 ENTR EXIT
Toggle to set the CONSTANT drive voltage of the O
3
generator
SETUP X.X O3 GEN SET POINT: 000.0 PPB
0 0 0 0 .0 ENTR EXIT
Toggle to set output concentration of the O
3
generator
MANUAL CAL GAS TYPE:ZERO
ZERO ENTR EXIT
SETUP X.X LEVEL NUMBER=0
0 0 ENTR EXIT
LEVEL NUMBER
EDIT
Toggle to set
LEVEL ID
Number
MAIN MENU SETUP LVL
1
EDIT
ONOFF
MANUAL STATUS BLOCK [1 or 2]: [0]0000000
<CH CH> [0] ENTR EXIT
ENTR
Toggle to select the
bit to be set
Toggle to set the
selected bit
REFOFF CNST
BNCH
STATUS BLOCK 1 STATUS BLOCK 2
To Next Page