TELEDYNE API T703U - Page 231

Teledyne API - Models T703, T703U, 703E MENU TREES (05745F DCN7107)APPENDIX A-5: Terminal Command Designators
A-17
APPENDIX A-5: Terminal Command Designators
Table A-5: Terminal Command Designators
COMMAND
ADDITIONAL COMMAND SYNTAX
DESCRIPTION
? [ID]
Display help screen and commands list
LOGON [ID]
password
Establish connection to instrument
LOGOFF [ID]
Terminate connection to instrument
T [ID]
SET ALL|name|hexmask
Display test(s)
LIST [ALL|name|hexmask] [NAMES|HEX]
Print test(s) to screen
name
Print single test
CLEAR ALL|name|hexmask
Disable test(s)
W [ID]
SET ALL|name|hexmask
Display warning(s)
LIST [ALL|name|hexmask] [NAMES|HEX]
Print warning(s)
name
Clear single warning
CLEAR ALL|name|hexmask
Clear warning(s)
C [ID]
ZERO|LOWSPAN|SPAN [1|2]
Enter calibration mode
ASEQ number
Execute automatic sequence
COMPUTE ZERO|SPAN
Compute new slope/offset
EXIT
Exit calibration mode
ABORT
Abort calibration sequence
D [ID]
LIST
Print all I/O signals
name[=value]
Examine or set I/O signal
LIST NAMES
Print names of all diagnostic tests
ENTER name
Execute diagnostic test
EXIT
Exit diagnostic test
RESET [DATA] [CONFIG] [exitcode]
Reset instrument
V [ID]
LIST
Print setup variables
name[=value [warn_low [warn_high]]]
Modify variable
name="value"
Modify enumerated variable
CONFIG
Print instrument configuration
MAINT ON|OFF
Enter/exit maintenance mode
MODE
Print current instrument mode
The command syntax follows the command type, separated by a space character. Strings in [brackets] are optional
designators. The following key assignments also apply.
Table A-6: Terminal Key Assignments
TERMINAL KEY ASSIGNMENTS
ESC
Abort line
CR (ENTER)
Execute command
Ctrl-C
Switch to computer mode
COMPUTER MODE KEY ASSIGNMENTS
LF (line feed)
Execute command
Ctrl-T
Switch to terminal mode
07223D DCN7107