Tonghui TH2829 Series - Hdl Val ID Time; Relay Act Time

TH2829X Series Operation Manual Chapter 7 Transformer Auto Scanning Test
96
7.7.17 HDL VAL ID TIME
On <TOOLS> page, move the cursor to HDL VAL ID TIME and press the number
to confirm. It ranges from 1-255 and indicates the valid time of handler signal is
1-255ms. When 0 or number greater than 255 is entered, ALWAYS is displayed
and it indicates the handler signal is always valid.
TH2829x720
7.7.18 RELAY ACT TIME
On <TOOLS> page, move the cursor to RELAY ACT TIME and press the number to
confirm. It ranges from 2-10 (ms) and indicates the switch act time of relay in
scan box or scan board. Due to the aging of the relay, appropriately increase the
act time to keep the measurement accuracy.
TH2829x721