Tonghui TH2829 Series - Baud Rate; Data;Time; Lcr <File Manage

TH2829X Series Operation Manual Chapter 4 [SYSTEM] and [FILE]
56
———————————————————————————————————————
Operation steps for setting bias source
1) Move the cursor to BIAS SRC, the following soft keys will be displayed.
 INT
 OPT
 TH1778
2) Press INT to select the INT bias source.
3) Press OPT to select the OPT bias source.
4) Press TH1778 to select the TH1778 bias source.
4.1.12 BAUD RATE
Baud rate is used select the baud rate of the RS232C interface. The available baud
rate of this instrument is from 9.600k to 115.200k.
Operation steps for setting the baud rate
1) Move the cursor to BAUD RATE, the following soft keys will be displayed.
 ↑（+）
This soft key is used to increase the baud rate.
 ↓（-）
This soft key is used to decrease the baud rate.
4.1.13 DATA/TIME
When moving to the time zone, user should input the password to enter.
4.2 LCR <FILE MANAGE>
TH2829X series instrument can save the user-set parameter to the nonvolatile
memory in the form of file, so when use the same setting next time user can load
a corresponding file to obtain the parameter set and used last time. By doing so,
it can save the time of setting parameter and improve the production efficiency.
The file manage function of the transformer scanning will be described in the part
of transformer test setting.
Press [FILE MANAGE] to enter into the file manage page, shown as below.