Tonghui TH2829 Series - On Beepers; Pass Beep; Fail Beep

TH2829X Series Operation Manual Chapter 4 [SYSTEM] and [FILE]
52
4.1.2 ON BEEPERS
This zone is used to control and display the beeper source.
Operation steps for selecting beeper
1) Move the cursor to Beeper, the following soft keys will be displayed.
 MASTER
This soft key is used to select the instrument as the beeper source.
 SCANNER
This soft key is used to select the scanner as the beeper source (available
only when TH2829X connects a transformer scanning box).
 ALL
This soft key is used to select both the instrument and the scanning box as
the beeper source.
4.1.3 PASS BEEP
This zone is used to control and display the beep mode when the test result is
qualified.
Operation steps for setting PASS BEEP
1) Move the cursor to PASS BEEP, the following soft keys will be displayed.
 HIGH LONG
This soft key is used to select high and long beep.
 HIGH SHORT
This soft key is used to select high and short beep.
 LOW LONG
This soft key is used to select low and long beep.
 TWO SHORT
This soft key is used to select two low and short beeps.
 OFF
This soft key is used to set the pass beep function OFF.
———————————————————————————————————————
Note: In the scanning box, the potentiometer is used to adjust the volume, so
when selecting SCANBOX as the beep source, you can only control the volume to
be long and short but not high and low.
———————————————————————————————————————
4.1.4 FAIL BEEP
This zone is used to control and display the beep mode as FAIL BEEP when the
test result is unqualified.
Operation steps for setting FAIL BEEP
1) Move the cursor to FAIL beep, the following soft keys will be displayed.