Tonghui TH2829 Series - LIST Subsystem Commands

TH2829X Series Operation Manual Chapter 10 HANDLER
168
Query syntax: FUNCtion:DEV<n>:MODE?
Return format:
ABX
PERC <NL^END>
OFF
The FUNCtion:DEV<n>:REFerence<value> command is used to set the nominal
value of the deviation. The FUNCtion:DEV<n>:REFernece<value>? query
returns the current nominal value of the deviation.
Command syntax: FUNCtion:DEV<n>:REFerence<value>
Where,
<value> is NR1, NR2 or NR3 data format.
<n> is
Character 1 (49) is equal to the nominal value of primary parameter.
Or character 2 (50) is equal to the nominal value of the secondary parameter.
For example: WrtCmd (“FUNC:DEV1:REF 10”)
Query syntax: FUNCtion:DEV<n>:REFerence?
Return format：<NR3><NL^END>
The FUNCtion:DEV<n>:REFerence:FILL command is used to set the nominal
value of the deviation. This command directs the instrument to make a test and
then copies the results of the primary and the secondary parameters as the
nominal values of the deviation.
Command syntax: FUNCtion:DEV<n>:RERerence:FILL
Where,
Character 1 (49) or haracter 2 (50)is equal to the nominal values of the primary
and secondary parameters.
For example: WrtCmd (“FUNC:DEV1:REF:FILL”)
9.1.10 LIST subsystem commands
The LIST subsystem commands are mainly used to set the list sweep function,
sweep points, sweep mode, sweep limits.
Command tree: